Air box for the new fan progressing...
Taken from the paper template then adjusted for even gaps top/bottom to accept rubber trim.
While everyting is in bits, the tunnel heater vents are changing too - rectangular peg into a round hole - but will mean I can reach them when buckled into the seatbelts.
The small cover panel will be at least blacked out and possibly carpeted so shouldn't notice once complete.
That should do the trick.
New ducts, the new vents need 55mm rather than the existing 50mm.
The important bit - just reachable from the seated/belted position.
No comments:
Post a Comment