I'm waiting on some radiator fixing clips - to set off my chain of events for an egnine run i.e.
Radiator clips
Mount radiator
Fit nose (for the last time)
Fit bonnet catches
Fit manifold (for the first & last time)
Start the engine
Meanwhile;
Time to prepare the front mudgaurds with their repeaters:
First up I checked them both; black = +ve, white = Ground; then 20mm holes to mount them; I used a spare washer for the template:
The step drill bit isn't my favourite tool - it tends to wander off centre & is difficult to control - it does leave a clean finish on GRP though & only needed a little further light filing to tidy up the reverse:
These do have a 'top' almost invisibly marked on the lens:
The G-clamps are to apply gentle pressure and hold the lamps in place; They have a bead of bond holding them tight applied from the inside:
